Wilson 6GHz Lightning Sure Protector with N-Female Connectors | 850050

Product Highlights

• 50 ohm coax lightning arrestor for booster and amplifier protection
• Supports wide-band operation from DC to 5.8 GHz
• N-Female to N-Female connectors for in-line installation
• Replaceable 90V gas discharge tube with multi-strike protection
• Weather-resistant construction for indoor or outdoor use
• Bi-directional surge protection
• Built-in grounding screw for optional ground wire connection

Top Benefits

• Protects your booster system where standard surge protectors can’t
• Works with all major 4G systems and is ready for 5G if needed
• Fits easily into existing 50 ohm setups with no signal loss concerns
• Installs quickly and doesn’t require special tools
• Holds up in harsh environments with minimal maintenance

The lightning arrestor installs in-line between your outdoor antenna and amplifier using standard N-Female connections. It should be placed as close to the building entry point as possible, before the cable reaches your amplifier.

Basic steps:

1. Disconnect power from your system.
2. Install the arrestor on the coax cable coming from the outdoor antenna.
3. Use a separate coaxial jumper cable to connect the other side of the arrestor to the amplifier input.
4. Use the built-in grounding screw to connect a grounding wire if required. The wire should run to a verified building ground.
5. Make sure all connections are hand-tight. Do not overtighten.
6. Reconnect system power and check for signal.
   

Installer tips:

• You will need an extra N-Male to N-Male jumper cable to complete the connection between the arrestor and the amplifier.
• Always ground the arrestor when used outdoors or in high-risk areas.
• Mount it in a weather-protected spot if possible.
• Avoid placing it near water runoff points or in direct pooling zones.
• Do not coil excess coaxial cable near the arrestor or amplifier.

Most installs take under 10 minutes and require only a coax wrench or adjustable pliers.