Wilson Signal Booster Reach Extreme RV Kit [Discontinued]

The Wilson Signal Booster Reach Extreme RV Kit is the best solution for people who need to boost signal in a large vehicle, like an RV, Motorhome, 5th-Wheel, etc, and need reliable voice calls and fast data. The Wilson Signal Booster Reach Extreme RV Kit uses the most powerful vehicle cellular amplifier on the market, the Drive Reach, to boost cell signal coming into the vehicle, but more importantly, amplifies it significantly back to the distant cell towers, so you can be as far as possible and still get quality cell signal. The Drive Reach amplifier enables you to be 2x further from the cell towers than it's predecessor, the Drive 4G-X. The Reach Extreme RV Kit boosts the 2G, 3G, 4G HSPA+, 4G LTE and 5G E networks for all of the major carriers in North America, so you have reliable calls and fast data speeds wherever you travel. The Wilson Signal Booster Reach Extreme broadcasts boosted signal wirelessly, so multiple phones and data devices can receive boosted signal at the same time. Coverage Inside of the Vehicle The inside coverage area that you receive from the Wilson Signal Booster Reach Extreme RV Kit will depend on the existing outside signal strength in the location where you're traveling or parked. In areas where you get a moderate existing outside signal, the 4G Extreme will provide a boosted signal up to 6 ft from the inside antenna. As the outside signal gets weaker, the coverage area will shrink, until the point where you may have to keep your phone within about 18 inches from the inside antenna to take advantage of the boosted signal. The ideal way to talk on the phone while moving around the vehicle would be to keep your phone near the inside antenna and use a bluetooth headset or speakerphone for mobility. Hotspots can also be left near the inside antenna giving you the fastest internet speeds possible while providing WiFi connectivity throughout the RV or large vehicle. Supported Carriers The Wilson Signal Booster Reach Extreme RV Kit supports the Voice, 3G, and 4G LTE networks from all major carriers in North America. It does not support any WiMAX or iDEN networks. AT&T 2G, 3G, 4G HSPA+, 4G LTE, 5G E Verizon 2G, 3G & 4G LTE Sprint 2G, 3G, 4G LTE T-Mobile 2G, 3G, 4G HSPA+ & 4G LTE US Cellular 2G, 3G & 4G LTE All other carriers using 800 MHz, 1900 MHz, and AWS 1700/2100 MHz Please Note: This signal booster kit will not work in most European, Asian, and African countries because the frequencies used there are different than those boosted by this equipment. Included Items weBoost Drive Reach Amplifier 850020 - DC Power Supply 311230 - weBoost Drive RV Spring Mount Antenna with 3-Way Mount and 14 ft Cable 955822 - 20 ft. RG58 Coax Cable with N-Male and SMA Male Connectors 311135 - Wide-Band Panel Antenna with N-Female Connector 970019 - SMB Plug to SMA Female Adapter Installation Overview Installing the Wilson Signal Booster Reach Extreme RV kit is very easy and can usually be done in just a few minutes. To start, mount the RV Antenna on the exterior of the vehicle using the included 3-way mount, and ensure that the antenna extends above the vehicle for a clear, 360 degree view. Run the 25 ft RG6 cable into the vehicle and connect the included adapter, then connect the cable to the amplifier's Outside Antenna port. Connect the 970019 adapter to the inside antenna cable, and then connect to the Inside Antenna port of the amplifier. Run the cable to the location where you plan to mount the inside antenna, and connect the inside panel antenna. You can mount the inside panel antenna to either the ceiling or the wall in the location where you'll be using your mobile devices the most. Power on the amplifier and you should immediately start receiving boosted signal.