Add-On Inside Panel Antenna Kit for 50 Ohm Signal Boosters | 309906-50N
Availability: In stock
Ships today if ordered by 3pm Eastern.
- Add an additional panel antenna to a 50 ohm signal booster system.
- Includes everything you need: panel antenna, cables, and splitter.
The Add-On Internal Panel Antenna Kit (SKU: 309906-50N) contains everything needed to add a second antenna to a 50 ohm signal booster system. A second antenna can be very helpful in situations where a home or office has areas that aren't adequately covered by a single antenna. For example, a building with an "L" shape may require one antenna in each of "wings" in order to provide a strong signal. A second antenna can also help with coverage in multiple rooms that have thick walls in between or with multiple stories where the floor does not allow a signal to pass between stories.
In the Box
The Add-On Internal Panel Antenna Kit includes the following components.
- Wilson 50 Ohm Full Band Panel Antenna (311135)
- Wilson 50 Ohm Signal Splitter (859957)
- Wilson 2' Ultra Low Loss Coax Cable (952302)
- Wilson 60' Ultra Low Loss Coax Cable (952360)
To install, connect the included 2 foot long coax cable to the internal antenna port on your amplifier. Then connect the included splitter to the other end of the 2 foot coax cable. From one of the outputs on the splitter, connect the coax cable and antenna that came with the signal booster system. From the other output on the splitter, connect the 60 foot coax cable and panel antenna that are included with this system.
Before permanently mounting the antennas, it's a good idea to temporarily place them where you think they should go, power on the system, and test the level of coverage you get in the space you're trying to cover. If you find spots that don't have adequate signal, try adjusting the antennas. If you run into trouble, you can always call our technical support representatives for help.