weBoost Drive Sleek Cradle Signal Booster | 470135
Availability: In stock
- Boosts the Voice, 3G, and 4G LTE networks from all carriers
- Supports one phone or data device at a time
- Phone must stay in the cradle to receive the boosted signal
You Should Choose This Kit If
You want a sleek, minimal signal booster that will improve the signal for your phone or mobile device while it sits in the cradle. The weBoost Sleek Cradle Signal Booster (470135) features a brand new vertical cradle design, so it's able to handle any size phone or mobile device, and will boost all networks on all carriers at the same time.
Will This Work For Me?
The weBoost Drive Sleek Cradle signal booster is our entry level vehicle signal booster that will boost the cell signal for one phone or mobile device as it sits in the cradle. If you need to only boost the signal for your phone and plan to use speakerphone or a headset when using your phone, then the weBoost Drive Sleek is a great option for you.
The weBoost 470135 Drive Sleek supports the 2G, 3G, and 4G LTE networks from virtually all carriers in the United States and Canada. Here is a more detailed breakdown of the carriers, networks and frequencies boosted by this kit:
- AT&T 2G/3G/4G HSPA+ (shows as 4G on your phone) & 4G LTE
- Verizon 2G/3G & 4G LTE
- Sprint 2G/3G
- US Cellular 2G/3G & 4G LTE
- Alltel 2G/3G
- T-Mobile 2G & 3G, 4G HSPA+ (shows as 4G on your phone), and 4G LTE
- All other carriers using 800 MHz and 1900 MHz
- weBoost Drive Sleek Cradle
- weBoost Signal Amplifier
- weBoost Low-Profile Outside Antenna
- weBoost DC Power Supply
Installing the Drive Sleek signal booster is very easy and since the installation is not permanent, it can be moved from one vehicle to another.
To begin the installation, mount the included antenna on the roof of the vehicle. Route the attached coax cable in through a door opening. To protect the cable, run it under the door seal. Connect the cable Drive Sleek amplifier, then connect the cradle cable to the other sideof the amplifier. Plug in the included power supply and connect it to the signal amplifier. When you place your phone in the cradle, you should see a stronger signal (it may take up to 30 seconds for your phone's signal strength display to update). If you already have a strong outside signal, you won't see any benefit from the Drive Sleek so try it in a place where you typically have signal trouble. For more information, check out the following video.
|System Type||Cradle - Phone must stay in cradle to receive boosted signal|
|Power Requirements||12 V, 1.5 A|
|User and Installation Manual||No|
|Frequency Bands||700 MHz, 800 MHz, 1900 MHz, 1700/2100 MHz (AWS)|
|Specific Frequency (Up/Down)||704 - 716 MHz / 734 - 746 MHz, 776 - 787 MHz / 746 - 757 MHz, 824 - 849 MHz / 869 - 894 MHz, 1850 - 1910 MHz / 1930 - 1990 MHz, 1710 - 1755 MHz / 2110 - 2155 MHz|
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.
Please note, the four largest carriers - AT&T, T-Mobile, Verizon and Sprint - and more than 90 regional carriers have given blanket consent for use of all boosters certified to the new FCC standards.