Wilson 801242 MobilePro Dual-Band Signal Booster Kit with 4" Antenna [Discontinued]
Availability: Out of stock
This product has been discontinued and is being replaced by the Wilson 460113 MobilePro Dual-Band Signal Booster Kit.
You Should Choose This Kit If
You need an all in one solution to provide boosted voice calls and 3G data for multiple phones or data devices in a vehicle or other small inside space. The MobilePro comes with a 4 in. magnetic antenna that sticks to the roof of your vehicle or to the included window mount for use inside and the included AC and DC adapters allow you to use the system in a vehicle, home, office, hotel room, airport, or anywhere else you need coverage.
If you're frequently in areas with very weak existing signal, the MobilePro with 12 in. outside antenna gives you a little more power from the larger antenna. For even more boosting power in your vehicle, our In-Vehicle Kit features a more powerful amplifier to boost weak signals even in fringe coverage areas.
Will This Work For Me?
The MobilePro signal booster is designed to boost the signal over very small areas, like the inside of vehicle. With a very strong existing outside signal, the MobilePro will boost the signal up to 6 ft. from the MobilePro amplifier. If you have a very weak existing outside signal, the phones and data devices will have to stay within 4 to 6 inches from the MobilePro to take advantage of the boosted signal, so you would need to use your phone with a Bluetooth headset.
The MobilePro improves the signals used for both voice calls and Internet access. In areas with a weak signal, the MobilePro will reduce dropped calls, improve call clarity and increase Internet data speeds.
All carriers that use the standard dual band frequencies (800 MHz & 1900 MHz) for voice and 3G data, including:
- AT&T 2G/3G/4G HSPA+ (shows as 4G on your phone)
- Verizon 2G/3G
- Sprint 2G/3G
- US Cellular 2G/3G
- Alltel 2G/3G
- T-Mobile 2G only in most locations
- Major Canadian Carriers 2G/3G
- All other carriers using 800 MHz and 1900 MHz
- Will not boost 4G LTE for any carrier
- 801240 - MobilePro Dual-Band Amplifier
- 301126 - 4" Mini Magnetic Mount Antenna with SMA-Male Connector
- 859977 - USB-A to USB-Mini Cable
- 859963 - DC to DC 5V Power Supply for Sleek and MobilePro
- 859969 - AC to DC 5V Power Supply for Sleek and MobilePro
- 901128 - Window Mount with Radial for Magnet Antennas
- 859946 - 13" Mobile Professional Zippered Carry Pouch
Installing the MobilePro signal booster is very easy and because nothing is permanent, it can be moved from one vehicle to another, or brought inside a home or office for use.
To install the MobilePro in a vehicle, mount the included antenna on the roof of the vehicle. Route the attached coax cable in through a door opening. To protect the cable, run it under the door seal. Connect the cable to the MobilePro Amplifier. Then just plug in the included 12V power supply and connect it to the MobilePro. When you place your phone near the amplifier, you should see a stronger signal (it may take up to 30 seconds for your phone's signal strength display to update). If you already have a strong outside signal, you won't see any benefit from the MobilePro so try it in a place where you typically have signal trouble.
|System Type||Wireless Coverage over a very small area|
Amplifier Gain Only. Does not include cables and antennas.
|Coverage Area||The maximum coverage area will be highly dependent on the existing outside signal strength. In areas with a moderate existing signal, you may get coverage up to 6 ft. from the MobilePro. In areas with very weak existing signal, you may only get coverage up to 4 to 6 inches from the MobilePro.|
|Connectors||MobilePro has an SMA-Female Outside Antenna Connector|
|Power Requirements||￼5.5 V DC, 0.9A|
|User and Installation Manual|
|Frequency Bands||800 MHz, 1900 MHz|
|Specific Frequency (Up/Down)||824 - 849 MHz / 869 - 894 MHz, 1850 - 1910 MHz / 1930 - 1990 MHz|
|Noise Figure||3 dB nominal|
|isolation||> 90 dB|
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.
Please note, the four largest carriers - AT&T, T-Mobile, Verizon and Sprint - and more than 90 regional carriers have given blanket consent for use of all boosters certified to the new FCC standards.